Introduction to Hammer crusher
Hammer Crusher is also called Hammer Breaker, hammer mill.The series of Hammer Crushers are regarded as the preferred equipments in small sand production line because they have the featuers of less investment, high efficiency. Discharge sizes are adjustable. They are suitable for crushing all the materials of brittle, medium hard, and compressive strength not over 300 Mpa, it is well known as limestone crusher.
The motor drives the rotor of the hammer crusher rotate at a high speed through the belt. The materials are sent into the entrance of the crusher. They are crushed by the high speed hammer from blowing,impacting, cutting,grinding. Below the rotor,there are sieves, the ltte size products among the crushing products can be discharged through the sieve. The large size products are brought back to the crushed area by the hammer from blowing and grinding until they reached the required size. At last, they are discharged through sieve of PC hammer crusher.
1 Hammer headwork adopt of new technology casting ,with wear and impact resistance.
2 Adjusting grain size to cater for customers'need.
3 Seal body structure solved the problems of crushing plant dust pollution and gray body leakage.
4 The overall design has attractive appearance, compact structure, less easy damaged parts, easy maintenance.
After the customers buy into the hammer crusher,you must operate according to the instructions to avoid unnecessary damage to the hammer.The following is Juxin machinery explain the hammer crusher installation test machine and operating procedures for everyone:
1. Position is important before you are ready to install,the foundation Close to the raw material and the broken equipment should be firm and reliable.
2. After position,hammer broken anchor must be fixed well by supporting bolt.
Set aside mine drainage groove according to the specification of the size of the angle and size.
3. The motor position is opposite to the feed inlet,the control system is easy to use and can be freely used.
4. Check strictly the connection of each part of the hammer to ensure reliable connection and check the state of lubrication.
5. If there is no problem,you can boot operation normally.
6. In the production of regular maintenance,it is critical that inspection hammer wear and lubrication system is normal and the maintenance.Found the malfunction of hammer crusher and timely maintenance,in this way it can go on a long-term efficient production.
If you are interested in our machines, pls contact us anytime.